{"id":984,"date":"2022-02-19T16:35:45","date_gmt":"2022-02-19T16:35:45","guid":{"rendered":"http:\/\/localhost\/rv10ca\/?page_id=984"},"modified":"2022-02-19T17:21:32","modified_gmt":"2022-02-19T17:21:32","slug":"lean-of-peak","status":"publish","type":"page","link":"http:\/\/localhost\/rv10ca\/lean-of-peak\/","title":{"rendered":"Lean Of Peak"},"content":{"rendered":"\n
Typically, my flying RV10 is flown Lean of Peak (LOP) in cruise. Some people are absolutely convinced that running LOP will cause catastrophic damage to an aircraft engine, others believe it will extend engine life WHEN DONE PROPERLY.<\/strong><\/p>\n\n\n\n There are are lot of resources available regarding LOP operations, I suggest Mike Busch’s videos (Savvy Aviation) are a good place to start. <\/p>\n\n\n\n In my case, I run LOP conservatively buy which I mean I only run LOP in cruise. Typically this means I am running at 65% power or less. I do not run LOP when climbing or when running at high power settings. I also monitor cylinder head temperature (CHT) values and keep them below 400 degrees at all times. This strategy eliminates any risk associated with LOP operations.<\/p>\n\n\n\n One of the advantages of LOP operation is that the engione runs cleaner and cooler. During my annual inspections I borscope my cylinders and <\/p>\n\n\n\n Normal exhaust valves should look like an evenly burnt pizza. This AOPA article discusses boroscoping exhaust valves : ANATOMY OF A VALVE FAILURE<\/a>.<\/p>\n\n\n\n